Enrollment New Admin, Supervisor or Enroller with Fingerprint and Password

To enroll an Admin, Supervisor or Enroller with just a password, Press ‘MENU’ on the key pad. This will bring up the menu below. Note that the administrator will need to verify their identity with their fingerprint to access this menu.

 

‘User Manage’ is selected. Press ‘OK’.

 

 

Arrow down to select ‘Enroll Admin’. Press ‘OK’.

Arrow down to select ‘FP & Pwd’. Press ‘OK’.

 

‘Admin’ is automatically selected. If you would like to enroll a Supervisor or Enroller, arrow down until your choice is highlighted, then press ‘OK’.

 

 

Press ‘OK’ to confirm you would like to create a new enrollment.

The next available User ID number will automatically be selected. You can also enter in a number (the range is 1 through 65534). Press ‘OK’.

 

Place the finger you wish to store onto the fingerprint pad. It will prompt you when to remove your finger. In order to get an accurate fingerprint, you will do this three times.

**Always place finger FLAT on the CENTER of the sensor surface. Placing the finger too low, too high, too far left or right and/or not flat on the fingerprint surface can create errors.**

 

                  

Place the same finger onto the fingerprint pad again.

 

 

Place the same finger onto the fingerprint pad for the 3^rd and last time.

 

To save the new enrollment, press ‘OK’. (To start over or cancel, press ‘ESC’)

**Note: If you have more than one password saved, the number of the password you are now saving is the last number (ex. 00003-2 shows that user ID 3 already has passwords saved).

 

Reenter password and press ‘OK’.

 

To continue with a new enroll, press ‘OK’.

 

Press ‘OK’ to continue.

 

 

Press ‘OK’ to confirm you would like to enroll a fingerprint and password for a new user.